1ANEMOMETER TRANSMITTER KIT INSTALLATION MANUALThis manual describes how to install the Anemometer Transmitter Kit for a Wire-less Vantage Pro2TM
10A Note on Securing CablesTo prevent fraying or cutting of cables, secure them so they will not whip about in the wind. Secure a cable to a metal pol
11When replacing the cups, make sure they are not rubbing against any part of the anemometer head. “Wind readings aren’t what I expected them to be.”B
Product Numbers: 6332, 6332OVDavis Instruments Part Number: 07395.237 Anemometer Transmitter Kit Installation Manual Rev. A Manual (10/15/04)This prod
2Installation StepsThe following is an outline of the steps necessary to install the Anemometer Trans-mitter Kit. These steps are used as section head
33. Remove the hex nuts and washers holding the rain collector side on the pole. Retrieve the U-bolt that was holding the anemometer. 4. Using the was
45. Locate the DIP switches. You will work with them during the next installation step. Setting the Transmitter IDEach wireless transmitting station m
5Setting Console/Receiver(s) to Same ID1. Put your console into Setup Mode — press and hold DONE and press the DOWN arrow (-). The console will show y
6Test ModeDIP switch #4 on the SIM (see illustration on page 6) is the TEST DIP switch. Switch it to the ON position using a ball-point pen or paper c
7Range of Wireless TransmissionThe range of your radio transmission depends on many factors. Try to position the transmitter shelter and your console/
83. Swivel the ane-mometer until the arm is pointing north, if possible. 4. Using an adjust-able wrench or 7/16" wrench, tighten the nuts. If the
9Mounting Transmitter Shelter on a Pole1. While holding the shelter against the pole, place a U-bolt around the pole and through the two holes on at t
Comments to this Manuals