DAVIS Vantage Pro2 ISS Installation Manual download pdf (Page 5)

Preparing the ISS for Installation

• Apply power to the ISS and test communication with the console.

• Change the Transmitter ID for wireless communication, if necessary.

Assemble the Anemometer

The anemometer measures wind direction and speed. The anemometer arm comes

partially assembled with the wind vane attached. The anemometer arm requires

assembly before it can be assembled with the rest of the ISS.

Please locate the following parts to prepare the anemometer:

• Anemometer arm (wind vane and cable already attached)

• Anemometer base

• Wind cups

• Drip ring

• Allen wrench (0.05")

• #4 machine screw, #4 tooth-lock washer, #4 hex nut

Attaching Anemometer Arm to Base

1. Insert the anemometer arm into the base, sliding the cable through the notch in the

base as shown in illustration.

2. Be sure to line up the small hole in the arm with the holes in the base.

3. Insert the machine screw through the holes in the base and arm.

4. Slide the tooth-lock washer and hex nut onto the machine screw. Tighten the hex

nut while holding the screw with a Phillips head screwdriver to prevent it from

turning.

5. Press the sensor cable firmly and completely into the zig-zagging channel in the

base, starting from the arm and progressing downward to the bottom of the base.

Insert

anemometer arm

into base

Slide cable

through notch

#4 Tooth

Lock Washer

Hex Nut

#4 x 1-1/8”

Machine Screw

IMPORTANT:

Make sure cable

is secure in channel

1 2 3 4 5 6 7 8 9 10 ... 31 32

No comments

DAVIS Vantage Pro2 ISS Installation Manual Page 5