DAVIS 8126GD Installation Manual download pdf (Page 8)



,167$//,1*'5,9(5,*+7

&  Always use safety stands when working under a raised vehicle. Never work under a

vehicle supported only by a jack.

3URFHGXUH,QVWDOOWKH6SHHG6HQVRU

The speed sensor used by the DriveRight GD and HD consists of a magnet

mounted on the driveshaft or CV-joint hub and a reed switch.

1. Mount the magnet on the vehicle’s driveshaft or CV-joint hub.

2. Assemble the reed switch bracket.

3. Install the reed switch.

4. Route the sensor leads into the vehicle.

,QVWDOOWKH0DJQHW5HDU:KHHO'ULYH

For a rear wheel drive vehicle,

the magnet mounts on the

driveshaft close to the

transmission. The sensor

mounts adjacent to the magnet

on the vehicle’s chassis or floor

pan.

If you are installing a DriveRight HD, see the special magnet mounting instructions in the

“Supplement for DriveRight HD” on page 20.

Select a mounting location on

the drive shaft within 12 inches

(30cm) of the universal joint to

account for vehicle suspension

movement while driving.

❏ The mounting location should provide a clearance zone around the

driveshaft of at least 3/4” (19mm) and a 3/8”-1/2” (10 - 13 mm) gap

between the magnet and reed switch.

Rear Wheel Drive

Installation

Drive Shaft

12" (30 cm)

Rear Wheel Drive Mounting Positions

3/4" (19 mm)

Minimum Clearance

3/4" (19 mm)

Minimum Extension

3/8" - 1/2" (10 - 13 mm) Gap

07395.043 DR GD Inst Rev D Body D146.fm Page 6 Monday, December 1, 2003 12:02 PM

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

No comments

DAVIS 8126GD Installation Manual Page 8