DAVIS DriveRight 8130 Installation Manual download pdf (Page 7)

DriveRight GPS/Wireless Wiring Diagram

Making Connections

The GPS/Wireless Interface Module for DriveRight can be installed with

either the GPS Module, the Wireless On-Board Module or both. The

instructions below assume an installation involving all three modules.

Modify your own installation as necessary.

1. Connect the GPS Module to the GPS/Wireless Interface Module by

plugging the male connector of the GPS Module cable into the socket

labeled “GPS” on the GPS/Wireless Interface Module.

2. Connect the Wireless On-Board Module to the GPS/Wireless Interface

Module by plugging the male connector on the Wireless On-Board Module

cable into the socket labeled “W” on the GPS/Wireless Interface Module.

3. Disconnect the DriveRight 600

E device or optional SmartCard On-Board

Reader cable from the Digital Adapter Cable.

4. Connect the male connector from the GPS/Wireless Interface Module cable

to the female connector on the Digital Adapter Cable.

5. Connect the female connector on the GPS/Wireless Interface Module to the

male connector on the DriveRight 600

E, or optional SmartCard On-Board

Reader cable.

See the diagrams below for properly disconnecting and connecting cables:

Disconnecting Cables:

Hold both cables by their connector housing and pull apart.

The housing of the male connector slides to separate the cables.

Connecting Cables:

Slide

Connector Housing

Hold the female connector and push the male connector from behind the housing, allowing

the housing to slide back. The cables lock together when a connection is made.

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

No comments

DAVIS DriveRight 8130 Installation Manual Page 7