Davis Weather Monitor II EZ-Mount User Manual download pdf (Page 3)

Getting Started Page 3

ETTING

TARTED

Follow the steps below to install your station. At various stages of this installa-

tion, you will be advised to test the system to ensure proper functioning.

1. Detach and remove the extension tube from the support tube by cutting the two

black cable ties.

2. Attach the anemometer arm to the support tube as shown below. Make sure that the

anemometer is positioned over the white ﬁeld case and NOT over the black rain col-

lector cone.

3. Attach the wind cups to the anemometer.

Push the wind cups onto the shaft as far as they will go, then tighten the set

screw. The cups should drop slightly and into the ideal position automati-

cally. Spin the wind cups. If they do not spin freely, loosen the set screw and

lower the cups slightly. Repeat until the wind cups spin freely.

Anemometer Arm

Support Tube

Anemometer

Cable

#12 x 1-1/2"

Screw

Lock

Washer

Hex

Nut

Cable Tie

Anemometer

a. Push cups onto

stainless steel shaft

b. Tighten set screw

with allen wrench

1 2 3 4 5 6 7 8

No comments

Davis Weather Monitor II EZ-Mount User Manual Page 3