Davis Wheel-a-Weigh Kayak Dolly User Manual

Browse online or download User Manual for Accessories for water Davis Wheel-a-Weigh Kayak Dolly. DAVIS Wheel-a-Weigh Kayak Dolly User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 2
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
#1471
ASSEMBLY INSTRUCTIONS
This product is not to be used on boats over 200 lbs.
(91 kg). Capacity is reduced to 100 lbs. (45 kg) on
soft sand.
1. Slide strut into bunk and tap into place, making sure
the strut locks into retainer on both sides. Check from
top of bunk.
2. Slide strut onto the axle with the sloped side facing
out. Line up the hole in the strut with the second hole
in from the end of the axle (the second hole has a roll
pin in it). Attach strut to the axle with 1/4" (6.5 mm)
lockpin, which is the smooth pin. Repeat process on
opposite end of axle. The foot rod should be on the
bottom of the axle (see diagram).
CARRYING THE KAYAK
In use, the boat is usually positioned on the bunks just
off the balance point with weight bias toward the bow.
The foot rod is used to hold the dolly upright while the
boat is being loaded.
3. Thread the straps through the built-in strap guides on
the bottom side of the bunks and then install the
buckles.
4. Inflate tires to NO MORE THAN 14 P.S.I. (14 pounds
per square inch). Use no more than 14 pounds tire
pressure regardless of what may appear on the
tire.
CAUTION: Gas station compressors can easily
overinflate and explode tires. Be careful not to
overinflate.
5. Mount the wheels and attach to 1/2" (1.3 cm) axle by
installing 1/4" (6.5 mm) cotter-type pin on outside of
wheel to prevent it from sliding off.
KAYAK DOLLY
CAUTION: This product is not designed to be towed
behind a vehicle. Damage may occur and will void
the warranty.
Page view 0
1 2

Summary of Contents

Page 1

#1471ASSEMBLY INSTRUCTIONSThis product is not to be used on boats over 200 lbs.(91 kg). Capacity is reduced to 100 lbs. (45 kg) onsoft sand.1. Slide s

Page 2 - ONE-YEAR WARRANTY

REPLACEMENT PARTSPart QtyNo. Description Req’dR1471A Tire, Innertube and Hub 2R1464B Strut and Bunk 2R1471B Pin Set: 2Lockpin , 1/4" (6.5 mm), an

Comments to this Manuals

No comments