DAVIS 7627 Installation Manual download pdf (Page 22)

•If possible, mount the wireless repeater as high as possible (on a pole or atop a building)

to overcome transmission limitations caused by the ground. See “Mounting the Wireless

Repeater” on page 30 for more information.

Testing a Proposed Location

After a suitable location has been chosen in an area between the station and console, it is

very important to test reception between the station, repeater, and console before perma-

nently mounding the repeater.

1. Place the repeater in the desired location.

2. Put the repeater back in test mode (turning the Repeater DIP #4 switch on) if test mode

has been turned off. If the repeater LEDs flash the normal operation light pattern (The

STAT LED flashing green with the TX LED flashing green), the repeater is success-

fully receiving a signal from the station.

3. In the console’s Current Weather Mode (the screen that displays in the console’s nor-

mal operation), view the station ID number displaying in the bottom of the screen. If

the station ID displaying is the station transmitting through the repeater, the console is

successfully receiving a signal from the wireless repeater.

4. Once the console successfully receives a signal from the repeater, press WIND to see

the wind direction field. When the degree (º) sign is visible in the center of the wind

compass rose, the strength of the signal coming from the station transmitter to the

repeater is displayed. See “Network Signal Strength” on page 32 for more information

on this field and its importance.

Note: This signal strength is only displayed while the repeater in test mode.

5. Turn the repeater DIP switch #4 off once the test is complete, otherwise it will signifi-

cantly shorten battery life.

6. Close the repeater enclosure.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 47 48

No comments

DAVIS 7627 Installation Manual Page 22