DAVIS Vantage Pro2 ISS Installation Manual download pdf (Page 17)

Additional Mounting Options: Finishing the Installation

3. Swivel the anemometer until the arm is pointing north.

If the anemometer arm is not pointing north, go to “Appendix C: Re-orienting the

Wind Vane” on page 21 after tightening the nuts.

4. Using an adjustable wrench or 7/16" wrench, tighten the nuts.

Finishing the Installation

Level the Solar and UV Sensors

If your station includes a solar or UV sensor, use the bubble level on the sensor as a

guide to verify that the sensor is level.

You can adjust the level by tightening or loosening the screws that hold the sensor onto

the shelf.

Securing the SIM Cover

We recommend using screws

to securely fasten the SIM

cover.

1. Make sure the SIM cover is

completely closed with the

plastic latches engaged.

2. Secure the SIM cover

using the two #6 1/2” (3.5

mm x 12 mm) screws

included in the ISS hard-

ware.

Note:Plastic latches alone may not keep the SIM cover fastened during windy conditions. Use screws

to secure the SIM Cover in place.

Clearing Data Collected During Testing and Installation

Now that your ISS is mounted outside, you may want to clear out all data that was

collected in the Vantage Pro console during testing and mounting.

To clear all the collected data in the console:

1. Select the WIND key on the console so that graph icon appears adjacent to the wind

data on the display.

2. Press the 2ND key, then press and hold the CLEAR key for at least six seconds and

until you see “CLEARING NOW” in the console ticker display.

Additional Mounting Options

Extending Wireless Transmission Range

You can use our optional repeater stations to extend the wireless transmission range:

• Wireless Repeater, AC-Powered #7624

• Wireless Repeater, Solar-Powered #7625

Extending the Console Cable (Cabled ISS Only)

You can install a Cabled ISS up to 1000’ (300m) away from the console by using our

extension cables, #7876.

Secure cover with two (2)

self-threading screws

#6 x 1/2" (3.5 x 12 mm).

SIM Cover SIM Housing

Close cover. Make sure

plastic latches engage.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments

DAVIS Vantage Pro2 ISS Installation Manual Page 17

Comments to this Manuals

Related products and manuals for Dehumidifiers DAVIS Vantage Pro2 ISS