DAVIS Vantage Pro2 ISS Installation Manual download pdf (Page 4)

Preparing the ISS for Installation: Tools for Setup

Hardware

Tools for Setup

• Small Phillips-head screwdriver

• Scissors or wire-cutters

• Adjustable wrench or 7/16" wrench

• Compass or local area map

• Ballpoint pen or paper clip (small pointed object of some kind)

• Drill and 3/16" (5 mm) drill bit (if mounting on a vertical surface)

Preparing the ISS for Installation

Please follow the steps in the order they are presented. Each step builds on tasks com-

pleted in previous steps.

Note: We recommend using a well-lit worktable to prepare the ISS for installation.

The steps to prepare the ISS for installation are:

• Assemble the anemometer

• Check the factory-installed sensor cable connections to the SIM.

• Connect the anemometer sensor cable to the Sensor Interface Module, or “SIM”.

• Apply power to the ISS and test communications with the console.

• Change the transmitter ID for wireless communication, if necessary

Assemble the Anemometer

The anemometer measures wind direction and speed. The wind vane is already attached

to the anemometer arm, but you will need to install the wind cups and attach the arm to

the base.

Please locate the following parts to prepare the anemometer:

• Anemometer arm (wind vane and cable already attached)

• Anemometer base

• Wind cups

• Drip ring

• Allen wrench (0.05")

• #4 machine screw, #4 tooth-lock washer, #4 flat washer, #4 hex nut

1/4" Flat Washers (4)

1/4" Lock Washers (4)

1/4" Hex Nuts (4)

3-Volt Lithium Battery

(Wireless ISS only)

U-Bolts (2)

Backing Plate

.05" Allen

Wrench

1/4" x 3" (~6 x 75 mm)

Lag Screws

#4 x 1-1/8"

Machine Screw

#4 Tooth Lock Washer

#4 Flat Washer

#4-40 Hex Nut

8" Cable Tie

#6 x 1/2"

(3.5 x 12 mm)

Self-Threading Screws (2)

1 2 3 4 5 6 7 8 9 ... 23 24

Comments to this Manuals

No comments

DAVIS Vantage Pro2 ISS Installation Manual Page 4

Comments to this Manuals

Related products and manuals for Dehumidifiers DAVIS Vantage Pro2 ISS