DAVIS and Vantage Pro Troubleshooting Guide download pdf (Page 24)

3. Using Your Weather Station



Clear All Command

After you have completed the above setup procedures and have exited the

Setup Mode, please use the Clear All command before putting your weather

station into service.

Note:

The Clear All command clears all stored high and low weather data including monthly and

yearly highs and lows and clears the alarm settings.

1. Press the WIND key on the console.

2. Press the 2ND key, then press and hold the CLEAR key for at least six

seconds.

3. Release the CLEAR key when you see the following message displayed

at the bottom of the console’s screen: “CLEARING NOW”.

Current Weather Mode

The Current Weather Mode displays the current data readings from your sta-

tion, select units of measure, and also to calibrate, set or clear weather vari-

ables. You can see up to ten weather variables on the screen at the same

time, as well as the time and date, the moon and forecast icons, a forecast

or special message from your station, and a graph of the currently selected

variable. A few variables are always visible on the console screen while

most variables shared their location with one or more other variables. You

can select any variable not currently on the screen to display it.

Selecting Weather Variables

Select a weather variable to display it’s data on the screen if it isn’t already

visible or to graph the variable in the Current Weather Mode screen.

Weather variables are selected via the console command keys:

• If the variable is printed on a key, just press the key to select the

variable.

• If the variable is printed on the console housing, first press and

release the 2ND

key, then quickly press the key below the variable to

select it.

Note: After pressing the 2ND key, the screen displays the 2ND

icon for three

seconds. Command key secondary functions are enabled during this time. The

keys return to normal operation after the icon disappears.

• You can also select any variable currently displayed on the LCD

screen using the +, - , <, and > navigation keys. Push + to move up

the screen. Push - to move down the screen. Push < to move left and

push > to move right.

• The console places a graph icon on the screen to indicate

the currently selected variable.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 59 60

Comments to this Manuals

No comments

DAVIS and Vantage Pro Troubleshooting Guide Page 24

Comments to this Manuals

Related products and manuals for Software DAVIS and Vantage Pro