DAVIS Rain Collector User Manual download pdf (Page 4)

Installing the Rain Collector Heater

Earlier versions of the rain collector did not come with built-in holes for the

rain collector heater. If your rain collector does not have built-in holes you

need to drill them yourself following the instructions below. Otherwise,

skip to step 5.

Marking screw holes

3. Using a drill with a 5/32” (4mm) or a 3/16” (4.8 mm) drill bit, drill holes in

the marked locations.

4. Using a drill bit with a large enough diameter to allow your power cable to

pass through, drill a cable hole in approximately the position shown below.

For the provided 50' (15 m) cable, use a 9/32'' (7.2 mm) or a 5/16'' (8 mm)

drill bit. The precise location of the power cable hole is not critical.

Power cable hole

1 2 3 4 5 6 7 8 9 10 11 12

No comments

DAVIS Rain Collector User Manual Page 4