DAVIS Rain Collector User Manual download pdf (Page 9)

Installing the Rain Collector Heater

9

11.Secure the cable to the heater

assembly by running a cable

tie over the cable and through

the hole as shown. You can

cut off excess cable tie.

12.To provide strain relief for

the cable, place a cable tie

around the cable just above

the hole through which this

cable is running, as shown

below.

You may want to cut off the

excess cable tie.

13.Re-attach (or attach) the rain

collector to the mounting

surface.

Installing the Insulation Blanket

1. Fit the insulation blanket against

the side of the rain collector

cone, pushing it as far inside the

cone as it will go.

If fully inserted correctly, the

blanket should extend all the

way to the top of the cone,

leaving a space of approximately

5/16” (8 mm) at the bottom to

accommodate the base.

2. Re-attach the rain collector cone

(with insulation blanket) to the

base.

Cable Tie

Securing cable to heater

Providing Strain Relief

Inserting the insulation

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments