DAVIS Sensor Mounting Arm User Manual download pdf (Page 12)

Page 12 Radiation Shield Manual

MOUNTING THE RADIATION SHIELD

Follow the instructions below to mount the Radiation Shield. There are sepa-

rate sections for each of the basic mounting options. You should modify the

instructions as necessary to ﬁt your needs.

Mounting On the Side of a Post or Wall

In order to mount the Radiation Shield onto the side of a post or wall, you will

need the Radiation Shield assembly, three #8 split lock washers, three #8 ﬂat

washers, and three #8 hex nuts. You will also need to supply four 1/4” x 1 1/2”

lag screws.

1. Using four 1/4” x 1 1/2” lag screws (not included), attach the mounting bracket to the

mounting surface in the desired location.

ATTACHING MOUNTING BRACKET TO THE SIDE OF A POST

2. Slide the stud ends protruding from the top of the Radiation Shield assembly into the

holes on the mounting bracket.

3. Secure the mounting bracket to the Radiation Shield using a #8 ﬂat washer, #8 split

lock washer and #8 hex nut one each of the stud ends.

Tighten until the mounting bracket is ﬁrmly attached to the Radiation Shield

ATTACHING RADIATION SHIELD TO MOUNTING BRACKET

#8 Lock Washer

#8 Hex Nut

#8 Flat Washer

Complete Plate

Assembly

1 2 ... 7 8 9 10 11 12 13 14 15 16

No comments

DAVIS Sensor Mounting Arm User Manual Page 12