DAVIS Sensor Mounting Arm User Manual download pdf (Page 13)

Mounting the Radiation Shield Page 13

Mounting on the Sensor Mounting Arm

In order to mount the Radiation Shield onto the Sensor Mounting Arm, you

will need the Radiation Shield assembly, three #8 split lock washers, three #8

ﬂat washers, and three #8 hex nuts, and the Sensor Mounting Arm.

1. Slide the stud ends protruding from the top of the Radiation Shield assembly into the

holes on the Sensor Mounting Arm.

2. Secure the Radiation Shield to the Sensor Mounting Arm using a #8 ﬂat washer, #8

split lock washer and #8 hex nut one each of the stud ends.

Tighten until the Radiation Shield is ﬁrmly attached to the Sensor Mounting

Arm.

ATTACHING RADIATION SHIELD TO SENSOR MOUNTING ARM

Mounting on a Pipe

In order to mount the Radiation Shield onto a metal pipe with outside diameter

between 1” and 1 1/4” (25 mm and 31 mm), you will need the Radiation Shield

assembly, three #8 split lock washers, three #8 ﬂat washers, three #8 hex nuts,

two 1 1/2” U-bolts, four 1/4” ﬂat washers, and four 1/4” hex nuts.

1. Slide the stud ends protruding from the top of the Radiation Shield assembly into the

holes on the mounting bracket.

#8 Lock Washer

#8 Hex Nut

#8 Flat Washer

Complete Plate

Assembly

1 2 ... 8 9 10 11 12 13 14 15 16

No comments

DAVIS Sensor Mounting Arm User Manual Page 13