DAVIS 7627 Installation Manual download pdf (Page 27)

Verifying Communication with Multiple Transmitters

Note: All transmitters in the network must have unique IDs in order for any repeater to communicate with them.

1. Find out and record all the Transmitter IDs the wireless repeater will repeat. Use the

“Transmitter and Repeater ID Worksheet” located inside the front cover to record the

transmitter IDs used. See “Verify Transmitter ID” on page 13 for information on

determining the Transmitter ID for all stations in the network.

2. On the Transmitter ID switch, set all the Transmitter IDs you want the repeater to

acquire to ON and make sure all the other Transmitter IDs are set to OFF.

3. Put the repeater into Test Mode by turning on repeater DIP Switch #4. When trying to

acquire stations, the repeater goes through the following process:

•It looks for a station signal for ten minutes, with the STAT LED flashing red when it

detects a signal not associated with a station during this time.

•It flashes yellow if it has found some stations but not all, and then;

•It flashes green when all stations are found. For each station found, the TX LED

flashes immediately after the STAT LED, indicating that it is repeating the data from

that station.

Note: See “Maintenance and Troubleshooting” on page 36 if the above LED pattern does not display.

4. Turn the Repeater DIP Switch #4 to OFF once the test is complete, otherwise it will

significantly shorten battery life.

Repeater

Vantage Pro2

Console/Receiver

Transmitter DIP

Switch with

IDs 1, 2, 3 ON

Repeater DIP

Switch set to ID A

Vantage Pro2

Station

Vantage Pro2

Station

Vantage Pro2

Station

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 47 48

No comments

DAVIS 7627 Installation Manual Page 27