Davis Vantage Connect Retrofit Kit (6626) User Manual Page 1

Vantage ConnectRetrofit KitFor Vantage Pro2 , Vantage Pro2 Plus , Vantage Vue and Weather EnvoyProduct number 6626™™Davis Instruments, 3465 Di

8Using Solar Power to Power the Vantage Connect Retrofit Kit in the FieldYou can power the Vantage Connect Retrofit Kit on solar power if needed. Keep

9Troubleshooting My status LED is not blinking.Make sure the power cord is connected. If power is connected and the LED is still off, open the Retrof

Appendix A: Switching Data LoggersTo switch out a USB data logger for a serial data logger:1. If you are using a console, enter Setup Mode (press and

Vantage Connect Retrofit KitProduct Numbers 6626, 6626EU,6626UK, 6626G, 6626S, 6626SEU 07395.322 Rev. C, June 21, 2012For use with Vantage Pro, Vanta

1Welcome to Vantage Connect Retrofit Kit (6626)The Vantage Connect Retrofit Kit allows you to upload data from a Davis Vantage Pro®, Vantage Pro2™, or

2Hardware Requirements• Davis weather console, either Vantage Pro, Vantage Pro2, or Vantage Vue; or Weather Envoy (all sold separately)• WeatherLink s

33. Purchase a Vantage Connect Service Plan.Vantage Connect Retrofit Kit requires an annual service plan. Choose #6632, 6634, or 6636 in the version a

4Installation Set Up Modem and Antenna1. Attach the antenna to the Vantage Connect Retrofit Kit by screwing it into the threaded receiver on the cellu

5Connect to the Weather Station1. If you have not already set up your console or Weather Envoy, do so first. (See the instruction manual that came wit

6Power UpNote: It is important to register your Vantage Connect Retrofit Kit online and wait 5 to 10 min-utes BEFORE you power it up to avoid a delay

7Download Data From WeatherLink Network to PC You can download your data stored online to your PC through the WeatherLink software. This can be done m