Davis Vantage Connect Retrofit Kit (6626) User Manual download pdf (Page 11)

Troubleshooting

 My status LED is not blinking.

Make sure the power cord is connected. If power

is connected and the LED is still off, open the

Retrofit Kit and press the ON/OFF button

shown in the diagram. If the LED is still off, con-

tact technical support.

 My status LED is flashing or always on.

The speed at which the LED flashes or blinks indicates specific information. Use

the table below to ascertain what the condition is and what to do about it.

 No data is being uploaded.

Make sure status LED is showing normal function, otherwise the device has not

registered on the network. Check the serial cable, make sure it is connected to the

weather station. Check power to the weather station.

Note: In a Weather Envoy, it will not be obvious that power has been lost.

On/O Button

(seconds)

Off

(seconds)

Indicates What to do

2 0.1 No console detected Repower console. Check

connectors and cables.

0.1 0.1 No cell signal

detected

Move to a location with

cellular reception.

0.5 0.5 Starting up Wait for next step.

0.5 1.5

Logging on to cellu-

lar network

Wait for next step.

0.1 5

Logged on to cellu-

lar network, normal

function

No action needed.

Always Never System fault Contact Tech Support

1 2 ... 6 7 8 9 10 11 12

No comments

Davis Vantage Connect Retrofit Kit (6626) User Manual Page 11