Installing the Rain Collector Heater
7
For Vantage Pro2 rain collectors, secure the heater assembly to the rain
collector base using two #4 x 3/8 self-tapping screws, as shown below.
Securing the heater in an Vantage Pro2 rain collector
7. Using wire strippers or a knife, strip 3/8” (10 mm) of insulation from the
heater cable wires.
8. If you have a Vantage Pro2 rain collector, use a medium size Phillips-head
screwdriver to knock out the hole for the heater’s power cable.
9. Pass the heater cable wires up through the cable hole you just drilled (stand-
alone rain collector) or knocked out (Vantage Pro2 rain collector).
#4 x 3/8"
Self-tapping
Screws
Heater
Assembly
Knock-out
Hole for
Heater Cable
Comments to this Manuals